Yealink EHS36 Setup - Leitner Premium Headsets

More of a visual learner?

Click here for a video showing you how to get set up!

What we'll need:

1. RJ45 cord (short, flat cable)
2. RJ 12 cord (short, round cable)
3. Box that says "Yealink"

Note: We'll also need the connector cord that comes with the Leitner headset.

Yealink EHS36 with Leitner set-up:

1. Set the compat switches under the headset base to 1 and DHSG
2. Connect one end of the RJ45 cord to the AUX jack on the back of the Leitner base (this is the largest jack in the center of the base) and the other end into the left-hand side of the YEALINK box
3. Connect one end of the RJ12 cord to the other side of the Yealink box (the smaller side) and the other end to the EXT jack of the Yealink telephone.
   Note: If you're using an expansion module (sidecar), plug it into the last EXT port of the expansion module
4. Plug the Leitner connector cord (the one that came with the headset) into the 2nd to last jack on the back of the Leitner base. The other end will go into the HEADSET jack of the Yealink phone