How do I... on my Plantronics Voyager Legend?

Want all of this information in a visual format? Check out this sweet 5 minute YouTube video!

Disclaimer: We do not carry this headset so our knowledge is limited to the content of this article.

Find the Plantronics Voyager Legend here on Amazon! If you're looking for something new, check out our collection of Bluetooth headsets!

Controls

ON/OFF: Use the slide switch on the back of the headset to power the headset on. This is just above the charging contacts.

VOLUME: To adjust volume, use the Volume Up/Down switch. This is the top button on the back of the headset labeled + and -.

MUTE: To mute a call, hit the Voice Recognition Button (see photo below). Tap it again to unmute yourself.

ANSWER/END CALLS: To answer calls, hit the Answer Call button on the headset. This is the large button on the outside of the headset (see photo above). To end a call, tap the same button.

Charging

HOW: You can charge this on the charging stand, in the case, and on the USB charging cable.

WHERE: The magnet for charging is on the back of the headset under the On/Off button. Simply match that up to the magnets in the charger and you’re good to go!

NOTE: The charging case can even hold onto a charge so that you can charge this headset without plugging it into electricity. Just plug the charging case into the USB charger to charge it completely. On a complete charge, the case can charge your headset 2x before needing to be recharged.

Pairing

To put the headset into Pairing mode:

1. Power the headset on and press and hold the Answer Call button for about 3 seconds until you hear “Pairing.” (see photo above). OR you can also tap the Voice Recognition Button (see photo below) and say “Pair” into the headset
2. When the light on the headset flashes red/blue, it’s in pairing mode
3. Activate Bluetooth on your mobile device and set it to search mode
4. Select "PLT Legend" from the Bluetooth devices list and, if prompted, enter 0000 for the password.
5. Once successfully paired, the light on the headset will stop flashing red/blue and you will hear the headset say “Pairing Successful!”

Voice Recognition

To activate Voice Recognition, first tap the Voice Recognition Button, then wait until the headset says “Say A Command.”

Your headset is now ready to hear your voice commands!

For more information about Voice Recognition with the Voyager Legend, check out this article!

Computer Use

PAIRING: The USB Dongle Adaptor is pre-paired to your headset. Just insert it into a computer and turn the headset on. You should be good to go :)

SET UP: The headset and dongle should also load to your computer automatically, if not, set the Plantronics device up as the default device in your computer's sound settings. You can reach the sound settings by right-clicking the speaker icon on the bottom right side of the computer screen for Windows and by going to the System Preferences in a Mac.

SOFT PHONES: If you have a soft phone and need to be able to answer calls from your headset, that may be possible by downloading the Plantronics Hub software. Note: Your IT Team may need to approve or run any downloads to your work computer.