Aliph Jawbone 2 Basic Info and Reset

In case you are wondering, the Jawbone 2 is a Bluetooth headset that clips right to your ear. It is great for taking on the go in the car or in the office for your Bluetooth calls. Here is some basic information on it as well as some resets if things suddenly stop working correctly.

Jawbone basics

• Charge the headset for 50 minutes using the included DCA / USB charger before using

• The headset will go into pairing mode automatically the first time it turns on (indicated by a red and white flashing light on the talk button area

• To place the headset into pairing mode after the first time it's powered on: hold the “Talk” and “Noise Assassin” buttons together until the light starts alternating red then white.

• Jawbone’s patented Noise Assassin requires that the Voice Activity Sensor (VAS) be touching your face. If the VAS isn’t touching your cheek, the headset will not work properly.

In the box

• In the box: 3 different size earloops (headset comes standard w/size medium attached, small and large in the box)

• 3 different size earbuds (headset comes standard w/size medium attached, small and large in the box)

• AC / USB charger

Controls

• Turn the Jawbone headset ON or OFF by pressing the “Talk” button for 2 seconds.

• To answer or end a call, press the “Talk” button

• To reject a call, press the “Noise Assassin” button while the phone is ringing

• To change the volume during a call, press the “Noise Assassin” to cycle through the multiple volume levels

• To turn the “Noise Assassin” off or back on during a call, press the “Noise Assassin” button for two seconds. The “Noise Assassin” is always ON by default.

• To initiate voice dialing, press the “Noise Assassin” button for two seconds in standby mode (not on a call) and then speak a command

• To redial the last number called, triple tap the Noise Assassin button

• To turn off the LED light, press the “Talk” button 5 times while in standby mode

• To answer an incoming call while on a call (call waiting), press the “Talk” button

Resetting the jawbone

• Press and hold down the “Talk” button on the Jawbone.

• Connect the jawbone to the USB charger cable (the cable needs to be plugged into an active USB port or to the wall charger unit)

• Release the talk button – the LED indicator should glow red if the reset is successful

• Disconnect from the charger cable

Time for a new Bluetooth headset?

Many Jawbone users have made the switch to the Leitner LH370!